基于综合变异系数的地基承载力可靠性分析   总被引：2，自引：0，他引：2  

曹宇春  刘富玲 《岩土力学》2014,35(7):1950-1956

采用一次二阶矩法,考虑岩土参量变异系数的试验及历史数据,提出了基于综合变异系数的地基承载力简化可靠性与风险分析方法。利用提出的简化可靠性与风险分析方法,可在传统确定性分析的基础上,采用合理的变异系数,分别得到与地基承载力有关的可靠度、破坏概率和平均期望损失的最可能值及其变化范围,为提出优化的地基基础设计方案和工程决策奠定基础;相对于土重度和黏聚力,地基承载力可靠度对于内摩擦角的变化更加敏感;设计时可以综合考虑所需的安全系数、可靠度和破坏概率,确定合适的基础宽度或基底面积。当地基土的场地勘察统计结果的变异系数权重逐渐增加时,综合变异系数不断减小,其相应的地基承载力的可靠度逐渐增加,而相应的破坏概率逐渐减少。  相似文献   

考虑基础刚度影响的风机梁板式桩筏基础模型试验研究   总被引：2，自引：0，他引：2  

李婉  木林隆  连柯楠 《岩土力学》2014,35(10):2875-2880

梁板式桩筏基础作为新型风机基础,前景广阔,适当优化结构,可节约成本。采用大型室内模型试验,研究了梁板式桩筏基础在不同筏板刚度情况下的受力变形特性,同时讨论了桩土荷载分担比的关系。研究表明,在工作荷载范围内,适当增大筏板刚度,桩平均轴力增加,外圈桩承担的荷载增大,内圈桩的轴力减小,环梁及肋梁弯矩减小,但继续增加刚度,对桩身轴力、环梁弯矩、肋梁弯矩的影响并不大;随着荷载的增大,土体承担的荷载比逐步增大,趋于稳值。随着梁板式基础刚度增加,基础内外差异沉降减少,但是达到一定刚度后再增加刚度对变形影响较小。梁板式基础刚度的变化会影响基底反力分布的均匀性,且存在一个最优刚度,使基础底部反力分布最为均匀,本次试验中12梁的梁板式基础基底反力比6梁和实体基础更均匀。桩基的分布和梁的分布存在相互影响,改变梁的分布会影响桩顶力,而桩基在梁底下又会使梁的应力产生重新分布。研究成果可为设计桩筏基础提供参考依据。  相似文献   

铁路连续梁拱组合桥基于摩擦摆支座的减隔震研究   总被引：1，自引：0，他引：1       下载免费PDF全文

夏修身 《地震工程学报》2012,34(4):350-354

研究了铁路连续梁拱组合体系桥梁的支座减、隔震设计.针对该桥梁的特点提出了摩擦摆支座减、隔震设计的原则与方法;建立全桥计算模型,采用非线性时程分析方法重点分析了摩擦摆支座的减、隔震效果.结果表明,采用摩擦摆支座可以显著地减小结构顺桥向的最大地震弯矩及拱顶变形,横桥向的减、隔震效果受输入地震动的影响很大.  相似文献   

Nonlinear behavior of high-damping rubber bearings under horizontal bidirectional loading: full-scale tests and analytical modeling     

Masashi Yamamoto  Shigeo Minewaki  Harumi Yoneda  Masahiko Higashino 《地震工程与结构动力学》2012,41(13):1845-1860

Horizontal bidirectional loading tests are conducted for real-sized high-damping rubber (HDR) bearings with diameters of 700 mm (HDR700) and 1300 mm (HDR1300). The hysteresis loops of these bearings under bidirectional horizontal loadings are compared with those under unidirectional loadings. The results show that the bearing force measurement in the primary direction of loading increases when there is displacement in the orthogonal direction. Unusually, the maximum restoring force in the orthogonal direction to the primary loading direction occurs near zero displacement. On the basis of the observations of the restoring forces, a rate-independent model is proposed. This model simulates well the test results under both bidirectional loading and unidirectional loading. It can reproduce the irregular restoring forces characteristics around zero displacement as described above. Bidirectional loading induced twist deformation in the HDR bearings that increased local shear strains. This phenomenon results in an early failure as observed in HDR700. The additional shear strain is estimated based on the twist deformation measured by video image analysis. The comparison of the nominal total shear stress demonstrates that the increase of shear stress because of bidirectional loading occurs when the average shear strain is larger than about 200%. The larger the shear strain, the greater the bidirectional effect. It is shown that the nominal total shear stress of average strain of 350% under bidirectional circular loading pattern is approximately the same as the average shear strain of 400% under unidirectional loading. This means that the average shear strain of 350% under a bidirectional circular loading corresponds to a local shear strain of 400%. Copyright © 2012 John Wiley & Sons, Ltd.  相似文献   

具有可靠抗震性能的农居房屋设计     

范雷彪  李嘉昕  任忠 《华北地震科学》2012,30(2):68-72

从减少地震波吸收的角度考虑建筑物的安全性,对提升普通农居房屋的抗震性能提出一种新的设计思路。具体做法:一是设计并应用了新的建筑构件承载结构棒和新结构砌块砖;二是将框架结构技术有效应用到普通房屋的建造中,使普通农居房屋具有了框架结构的稳固作用效果;三是对墙体砖块采用捆绑加固手段,并将房屋的墙体结构和屋顶结构实现整体式连接;四是对地基结构进行改进,采用了减震和隔震手段。通过上述做法既加强了墙体强度,消除了应力集中的可能性,同时通过减轻屋顶重量达到降低、缓解地震作用力的目的。  相似文献   

Effects of bottom bracings on torsional dynamic characteristics of horizontally curved twin I-girder bridges with different curvatures   总被引：1，自引：0，他引：1  

Robiul Awall  Toshiro Hayashikawa  Takashi Matsumoto 《地震工程与工程振动(英文版)》2012,11(2):149-162

Curved twin I-girder bridges (CTIGBs) have low torsional stiffness that makes them vulnerable to dynamic loads.This study investigates the effects of bottom bracings on the torsional dynamic characteri...  相似文献   

设置抗拔型三重摩擦摆隔震支座框架结构地震响应分析     

王秀丽  彭和平  李晓东 《地震学刊》2014,(2):129-135

抗拔型三重摩擦摆隔震支座是一种新型隔震支座。以框架结构为例,利用ANSYS软件建立了6层和10层普通抗震结构和带该支座的基础隔震结构模型;通过模态分析,得到了结构的自振周期;通过地震响应分析,提取了6层框架隔震层和顶层的位移、加速度和剪力时程曲线,并提取了不同层数不同结构类型的各层间位移、加速度幅值。结果表明：与抗震结构相比,基础隔震结构周期显著增大;隔震结构的变形主要集中在隔震层,隔震层以上的结构基本为整体平动,结构的地震位移反应得到了有效的减小;采用抗拔型三重摩擦摆隔震支座能降低结构地震加速度反应;设置抗拔型三重摩擦摆隔震支座的多层数隔震结构的能量衰减不如低层数的隔震结构迅速。  相似文献   

An advanced numerical model of elastomeric seismic isolation bearings   总被引：1，自引：0，他引：1       下载免费PDF全文

Manish Kumar  Andrew S. Whittaker  Michael C. Constantinou 《地震工程与结构动力学》2014,43(13):1955-1974

The nuclear accident at Fukushima Daiichi in March 2011 has led the nuclear community to consider seismic isolation for new large light water and small modular reactors to withstand the effects of beyond design basis loadings, including extreme earthquakes. The United States Nuclear Regulatory Commission is sponsoring a research project that will quantify the response of low damping rubber (LDR) and lead rubber (LR) bearings under loadings associated with extreme earthquakes. Under design basis loadings, the response of an elastomeric bearing is not expected to deviate from well‐established numerical models, and bearings are not expected to experience net tension. However, under extended or beyond design basis shaking, elastomer shear strains may exceed 300% in regions of high seismic hazard, bearings may experience net tension, the compression and tension stiffness will be affected by isolator lateral displacement, and the properties of the lead core in LR bearings will degrade in the short‐term because of substantial energy dissipation. New mathematical models of LDR and LR bearings are presented for the analysis of base isolated structures under design and beyond design basis shaking, explicitly considering both the effects of lateral displacement and cyclic vertical and horizontal loading. These mathematical models extend the available formulations in shear and compression. Phenomenological models are presented to describe the behavior of elastomeric isolation bearings in tension, including the cavitation and post‐cavitation behavior. The elastic mechanical properties make use of the two‐spring model. Strength degradation of LR bearing under cyclic shear loading due to heating of lead core is incorporated. The bilinear area reduction method is used to include variation of critical buckling load capacity with lateral displacement. The numerical models are coded in OpenSees, and the results of numerical analysis are compared with test data. The effect of different parameters on the response is investigated through a series of analyses. Copyright © 2014 John Wiley & Sons, Ltd.  相似文献   

旋喷群桩复合地基承载特性的数值分析   总被引：2，自引：0，他引：2  

安关峰  张洪彬  刘添俊 《岩土力学》2012,33(3):906-912

旋喷桩加固软土地基在各种地基处理工程中得到了广泛应用。对旋喷桩的研究多数集中在其施工工艺的改进上,或者针对单桩的承载特性进行研究,而对旋喷群桩的承载特性则研究不多。根据工程实际情况,采用基于MIDAS-GTS的三维有限元分析技术,通过改变旋喷群桩的布置方式、桩弹性模量、桩长、桩径、桩距等设计参数及桩-土接触面等参数对旋喷群桩复合地基承载特性的影响进行了研究。研究表明：旋喷桩加固软土地基主要减小了地表至桩底深度范围内土体的竖向沉降,对桩底下方的土体沉降基本无影响;提高旋喷桩桩径及材料强度会提高复合地基承载能力;不同旋喷桩布置方式、桩-土之间是否设置Goodman接触面单元对地基承载能力基本无影响。  相似文献   

现浇X形混凝土桩竖向承载性状模型试验研究   总被引：1，自引：0，他引：1  

张敏霞  刘汉龙  丁选明  王智强 《岩土力学》2012,33(2):389-394

为研究现浇X形混凝土桩的荷载沉降特性及其荷载传递机制,利用河海大学的大型试验模型槽开展X形桩的足尺模型静载荷试验。通过在桩身设置的钢筋测力计及在桩底埋设的土压力盒,实测了在竖向荷载作用下X形桩与土相互作用时的工作性状。试验结果表明：X形桩的荷载沉降曲线为缓变型;桩侧摩阻力与桩端阻力随桩顶沉降的增加均呈递增性;但随着桩顶荷载的增加,桩侧摩阻力分担桩顶荷载比例却呈递减性,其分担桩顶荷载比例由初期的约90%下降到极限状态时的70%左右,而桩端阻力分担桩顶荷载的比例呈递增性,其分担桩顶荷载比例由初期的约10%上升到极限状态时30%左右。研究成果可为今后竖向受荷X形桩的设计与研究提供重要参考。  相似文献